Rank: Newbie
Groups: Registered
Joined: 4/11/2021(UTC) Posts: 7  Location: Benson AZ
|
I have the J1708 bus and am connected ok to adapter and dash works but I have a constant fault of ABS with a light on my MH dash. Fault ID 84 FM 2 CNT 0 (Wheel Based Vehicle Speed Data) The fault shows up on my old ScanGauge unit I can clear it there and it will come right back in the ScanGauge and I can get the BlueFire to see the fault and send it to my email but it does not show up on the Faults Page in the dash. When not connected to the adapter it will show sample faults on the Faults Page and sent the demo faults to my email.
|
|
|
|
Rank: Newbie
Groups: Registered
Joined: 4/11/2021(UTC) Posts: 7  Location: Benson AZ
|
After firmware update 3.19.1 Fault Codes DO show up in dash fault screen.
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The BlueFire Forum uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close